Build by Turner Motorsport in 2004. Cage built to IT SCCA IT Spec with NASCAR door bars and tubing. Started life as a 1995 325i Sedan with no rust, no accidents. Clean street car.
Car was most recently run in 2011, 2012 in SCCA ITR. Full SCCA log book. Clean chassis, no wrecks, all panels are original except for front right fender, hood, and nose panel.
A list of parts and/or modifications include but not limited too (off the top of my head).
-WRC OMP Carbon Fiber Seat w/floor mounts.
-Schroth Window Net
-Schroth Center Net
-Schroth 6 Point Harnesses
-Full Electrical Kill Switch
-Full SPA Fire system with engine bay and driver protection 6 nozzles.
-OMP Steering Wheel with Flat Bottom.
-Wired for Radio with push to talk button.
-AIM MXL Pro Data Acquisition Dash and Data Logging. Various sensors (speed sensor, rpm, oil pressure, etc etc.)
-Race Studio 2 Software Compatable with GPS Module.
-Carbon Fiber Floor Pan/ Dead Pedal (NLA)
-Carbon Fiber Dash filler plate with Gauges
-VDO Gauges (Water temp, Oil Pressure, Air/Fuel)
-EVO 3 Short Shifter w/ Billet Extended High shift knob.
-Turner IT Legal Rear Subframe Enforcement.
-Rear Trailing Arm Reinforcement.
-Reinforced Strut towers.
-Custom Race Diff 3 clutch variable ramp.
-Solid Aluminum Engine Mounts, Trans Mounts, Diff Mounts.
-Solid Aluminum Subframe bushings.
-Turner Race Adjustable Camber Plates
-Bilstein Groupe N Shocks/Struts 60mm Springs
-Delrin Front Control Arm Bushings
-Rally Road Solid Transmission Brace
-BMW Motorsport Xbrace
– Mountain Motorsports Front and Rear Sway Bars (NLA)
-Turner Front Adjustable Sway Bar Links
-Turner Rear Adjustable Sway Bar Links
– Z3 Steering Rack with bump stops.
-M50 with racing valve springs/Spare motor if interested.
-Euro Oil Filter Housing with oil cooler lines.
-E36 M3 Oilcooler
-Conforti Carbon Fiber Intake/ITG Filter
-Turner Dyno Tuned Chip
-Headers back complete Kromer Kraft Race Exhaust w/Borla Muffler.
-Stewart Water Pump with Aluminum Housing
-Turner Power Pulleys
-Turner Oil Pan Baffle Kit Oil Pump Nut Wired.
-Fan Removal Nut
-Sachs HD Clutch with Stock Dual Mass Flywheel.
-New OEM Brakes Rotors all around
-Hawk HT-10 Pads.
-Brake Cooling Ducts
-Carbon Fiber brake cooling backing plates
-New Wheels Bearings front and rear.
-New Turner Motorsport Wheel Studs.
-Turner Caliper Brass Bushing Kits.
-Kosei 17×8.5 Wheels.
-Front Carbon Fiber Lower Bumper Splitter (From Bimmerworld) NLA
-Euro Tail Lights and Front Corner lights
-Welded Sunroof Panel
-Turner Front and Rear Tow Straps/Bumper mounted.
I am sure I am forgetting things but I have records on the build and most of the parts/modifications done on the car since it was built.
99% of the work and parts are from Turner Motorsport. Please email me with questions, offers, or more information. Serious buyers only, no low ball offers please. Feel free to text or call Jay at 603 770 8215.